Dynamite autopower 300a manual6/2/2023 You need some good electronic repair skills, and equipment, to replace the problem components. When I charging a battery in other iRobot Roomba the battery was full charged. How do I dissassemble Brum to check battery and battery connections. The robot doesnt give me the uh-oh beeps to be charged.Ĭharging light doesnt go on when charging unit is plugged in. Irobot says that the entire unit needs to be replaced, but it has to have something to do with the charging mechanism.Īny Ideas Ive tried the system reset, and removingreplacing the battery. It shows a green charged light, but when I hit clean, all lightsvacuum, etc just go out and it stops. I examined the little circuit board inside but saw no visible indications that would isolate t. I had a shark handheld about 8 years ago and it developed the same problem. Obviously there is a circuit failure in the on board charging control. I can remove the battery and wire it to the power supply for charging and it will charge up and run the sweeper. Unfortunatey, there is no mechanism to turn off the charge cycle, so this is not practical.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
June 2023
Categories |